Frigidaire Pump and Motor Assembly 5303292169 OEM Part

Frigidaire and Electrolux are prominent brands under the Frigidaire product line, which also supplies Sears-Kenmore with various appliances. Presented here is a dishwasher pump and motor assembly designed to effectively circulate water through the appliance's spray arm. If there are issues with spray arm performance, it may be necessary to replace this component.

Although replacing the pump and motor assembly may appear complex, it involves a series of manageable steps. Start by disconnecting the dishwasher from the power source and turning off the water supply. Detach the drain line from either the garbage disposal or the sink drain. Proceed by opening the dishwasher, removing both the bottom and upper dish racks.

Subsequently, remove the spray arm at the base and release the clips of the feed tube. With a nut driver, take off the bottom access and tow panels. Disconnect the power cable from the junction box as well as the supply line from the inlet valve. Carefully extract the dishwasher from its enclosure, tilt it to one side, and disconnect the hose from the drain pump. Further, detach the wire harness from the pump, and disconnect the wires linked to the diverter and circulation motors.

After completing these steps, restore the dishwasher to an upright position and remove the pump and motor assembly from its housing. Install the replacement assembly, then reverse the outlined procedures to reassemble your dishwasher.

This authentic OEM part is suitable for use in dishwashers manufactured by Frigidaire, Electrolux, Gibson, Kelvinator, and Westinghouse.